Barracuda CloudGen Firewall
4 / 6
LED Color
Status
Meaning Installation
Meaning Operation
All LEDs Off
Off
Appliance is powered off or
installation has not initialized
far enough for LED control
when installation is started.
Appliance is powered off.
Power LED front side -
BLUE
Steady
-
Appliance is plugged in and
is on.
Status LED front side -
RED
Off
Installation has finished
successfully.
Box is running normally.
Status LED front side -
RED
Steady
After a hotfix installation, the
LED turns to red until the next
reboot in case the hotfix
installation failed. This feature
requires firmware 7.1.3 or
higher OR 7.2.2 or higher.
Appliance is halted and may
be disconnected, or an error
occurred preventing the
appliance from entering the
up state.
Status LED front side -
RED
Blinking
slowly (1/s
interval)
Normal installation.
Appliance is either booting,
shutting down, or performing
a system update.
Status LED front side -
RED
Blinking fast
(4/s interval)
Error during installation.
Appliance is in
mode.
Disc LED - GREEN
Blinking
Appliance is reading or writing
on storage.
Appliance is accessing the
internal storage.
Port LEDs -
GREEN/YELLOW
Left blinking
Data transfer – Yellow (10/100
Mbps)
Port in use.
Right steady
-
Port is on.
Acoustic Signal Frequency
Meaning
Beep
1 time
(.)
Appliance is booting.
Beep
3 times
(...)
Installation was completed successfully; appliance is halted for
reboot. After reboot, one beep will again indicate booting.
Beep
3 times long
(_ _ _)
Error during installation.
LED and acoustic signals may vary between different appliance models.
Serial Console Port
In order to establish a console connection to the appliance using an RJ45 serial cable, you need to
configure the serial port on the terminal using the following parameters:
