Baroness SP05A, Owner'S Operating Manual

Page: 68 / 76

Change of Hydraulic Oil Filter
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
If the hydraulic oil emulsifies or if it becomes
even slightly less transparent, change the oil
immediately.
Important
When replacing the hydraulic oil filter, be sure
to drain the oil into a container and discard it
in accordance with local laws and regulations.
Important
Use Shell Tellus S2V32 (or equivalent) as
hydraulic oil.
Remove the old filter cartridge.
1
2
ycfdh6-002
Change of Hydraulic Oil Filter_001
1 Fuel tank
2 Filter cartridge
Lightly coat the packing of the new filter
cartridge with hydraulic oil, and then install
the cartridge.
Screw in the filter by hand until the packing
contacts the mounting surface.
Then tighten additional 1/2 turn from that
point.
Supply hydraulic oil until it reaches the
specified level.
"Hydraulic Oil Supply" (Page 4-4)
Start the engine, and then stop it after 10 to
20 minutes.
1.
2.
3.
4.
5.
Make sure that there is no oil leakage at the
sealing surface of the filter cartridge.
Check the hydraulic oil level.
If it is low, supply hydraulic oil until it reaches
the specified level.
Change of Air Cleaner
A contaminated air cleaner element may cause
malfunction of the engine.
To maximize the life of the engine, replace the
air cleaner element at the appropriate times.
The timing for replacing the air cleaner
element is described below.
Replace the air cleaner element in
accordance with the Maintenance
Schedule.
If it is significantly contaminated, replace
it, even if the hours of operation do not
exceed the specified time.
Replace the air cleaner element by following
the same steps as for cleaning the air
cleaner.
"Cleaning of Air Cleaner" (Page 4-5)
6.
7.
1.
[1]
[2]
2.
SP05A
Maintenance
Page 5-16
Maintenance Work