22
5-3
Operation of the blade
●
For safety reasons, make sure that there are no people
or obstacles near the blade before raising or lowering it.
●
Do not operate the blade while the rake is down. Failure
to follow this precaution will result in damage to the rake
if the machine is reversed.
●
If the 3WD setting is used when operating the blade, the
front wheel will slip. Therefore, you should always switch
to 2WD for this operation.
●
Blade lever operation method
○ To lower the blade
......Push the blade lever
forward.
○ To raise the blade
......Pull the blade lever toward you and lower it to its resting position.
Blade lever
Blade
5-2
Operation of the brush
● The brush is used to provide the bunker with a smoother finish.
●
Brush lever operation method
Brush lever
Brush lever
●
In order to create a beautiful
surface, lift the sand using
the blade and then reverse
the machine while pressing
the raised sand down with the
blade.
○ To lower the brush
......Pull the
brush lever down toward the
brush.
○ To raise the brush
......Push the
brush lever back toward the
machine.
Adjust the height of the brush from the ground to suit the bunker
conditions.
The height of the brush from the ground can be adjusted to the 4
positions shown in the following figures.
Pin position:
Lowest
Travel
Pin position:
Highest
Heavy finishing
Pin position:
Third from bottom
Medium finishing
(Normal use)
Pin position:
Second from
bottom
Light finishing
