Baroness LM3210A, Owner'S Operating Manual, Page: 99 / 167

Important
Quickly returning the ignition key from the
"START" position to the "ON" position may
result in damage to the machine.
After the "BARONESS" logo and the yellow
and red LEDs go off and the parameters
(items and values such as the rotation
speed) appear, immediately set the ignition
key to the "START" position.
When the starter starts rotating and the
engine starts, slowly return the ignition key to
the "ON" position.
Important
Be sure to warm up the engine.
Otherwise, a hydraulic system malfunction will
occur.
Move the throttle knob to the "Low speed"
position, and then warm up the engine so
that the engine coolant temperature exceeds
50 °C.
Gradually move the throttle knob toward the
"High speed" position.
Procedure to Stop Engine
Set the traveling pedal to the neutral
position.
Apply the parking brake.
Set the reel rotation switch to the "Stop"
position.
Raise the mower units.
Shift the throttle knob to the "Low speed"
position, and then idle the machine for 1-2
minutes.
Switch the ignition key to the "OFF" position.
Make sure that the engine has stopped.
Parking and Stopping
Leaving the machine
Caution
If the brakes are not sufficiently effective, use
the wheel stoppers to secure the machine.
Caution
Never park the machine on a slope.
8.
9.
10.
11.
1.
2.
3.
4.
5.
6.
7.
Park the machine on level ground.
Apply the parking brake.
Stop the engine.
Remove the ignition key.
Install the rubber cap to the key switch.
Hook the mower lock levers (latches) for the
mower units #4 and #5.
Step off the machine to leave.
Move
Traveling Procedure
Caution
Under any circumstances drive the machine at
such a speed that you can stop it immediately
for emergencies.
Caution
When traveling, be sure to stop the reel
cutters and raise the mower units.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Start the engine.
"Procedure to Start Engine" (Page 5-18)
Make sure that all the mower units are raised
and the mower lock levers (latches) for
mower units #4 and #5 are hooked.
Depress the brake pedal to release the
parking brake.
Release the brake pedal.
Slowly depress the traveling pedal.
The machine starts traveling.
The machine stops slowly when the traveling
pedal released.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
Handling Instructions
LM3210A
Handling Instructions
Page 5-19
Parking and Stopping