Baroness LM3210A, Owner'S Operating Manual, Page: 98 / 167

1 Forward/backward adjustment lever
2 Tilt adjustment lever
3 Suspension adjustment handle
4 Suspension indicator
5 Armrest adjustment knob
6 Seat height adjustment knob
Start/Stop of Engine
Procedure to Start Engine
Caution
When starting the engine, the reel cutter
(cutting cylinder) may rotate slowly.
Before starting the engine, make sure that
there are no other people or obstacles around
the machine.
Important
When restarting the engine after it has been
turned off, wait until the electromagnetic pump
has fully stopped before restarting the engine.
The electromagnetic pump will stop
approximately 7 seconds after the key switch
is turned to the "OFF" position.
Important
When you restart the engine after the safety
device stops the engine, be sure to return the
ignition key to the "OFF" position first, and
then restart it.
Otherwise the engine does not start.
Important
Starter operation must take 15 seconds or
less.
If the engine does not start, stop using the
battery for 30 to 60 seconds to avoid
exhausting the battery.
Sit on the seat.
Make sure that the parking brake is applied.
Make sure that the knife rotation switch is in
the "STOP" position.
Make sure that the traveling pedal is in the
neutral position.
Move the throttle knob halfway from the
"Low speed" position toward the "High
speed" position. 1.
2.
3.
4.
5.
Switch the ignition key to the "ON (GLOW)"
position.
1
2
3
v2e27i-071
Procedure to Start Engine_001
1 OFF
2 ON (GLOW)
3 START
Important
When the ignition key is switched to the "ON"
position, "Warming up" may appear in the
monitor display.
Do not start the engine until the message
disappears.
Make sure that the glow plug is generating
heat, the "BARONESS" logo or "Warming
up" message appears in the monitor display,
and the yellow and red LEDs are lit.
2 3
1
Quality on Demand
v2e27i-027
Procedure to Start Engine_002
1 Monitor display
2 Yellow LED
3 Red LED
6.
7.
LM3210A
Handling Instructions
Page 5-18
Start/Stop of Engine