Baroness LM315GC, Owner'S Operating Manual, Page: 60 / 86

Caution
Before restarting the engine, be sure to close
the unload valve.
Stop the engine. "Procedure to Stop Engine"
(Page 4-22)
Apply the parking brake and chock the
wheels.
The unload valve is located at the lower right
of the frame.
While pressing the unload valve, rotate it 90
degrees (vertically) to open.
1
A B
gay3t1-008
Towing the Machine_001
1 Unload valve
A Onload
B Unload
While pressing the push button, release the
parking brake lever and remove the wheel
stopper.
Tow the machine slowly.
1.
2.
3.
4.
5.
Cutting Work
Cutting Work
Warning
Do NOT start to move or stop the machine
abruptly.
To do so is very dangerous. In addition, it may
damage the hydraulic system or result in oil
leakage.
Warning
Set the reel rotation switch to the "TRAVEL"
(reel stop) position except during mowing or
backlapping and using reel excess discharge
system.
Caution
In case of 2WD/3WD model, travel in 2WD
mode since it is dangerous to travel on steep
downward slopes, wet road surface or
downward slopes of wet lawn in 3WD mode.
Rear tire going into a skid may cause loss of
traveling control.
Caution
Be sure to install the grass catchers.
Otherwise, flying objects from the mower units
may hit your feet.
Important
In case of 2WD/3WD model, whenever the
reel rotation switch is set to the "MOW" (reel
rotation) position, the drive mode is put into
3WD regardless of the position of the
2WD/3WD selector switch.
Install the grass catchers.
Start the engine. "Procedure to Start Engine"
(Page 4-21)
Raise all mower units.
While pressing the push button, release the
parking brake lever.
Shift the throttle lever to the rabbit icon (high
speed) to run the engine at the maximum
speed (3,000 rpm).
Set the reel rotation switch to the "MOW"
(reel rotation) position. 1.
2.
3.
4.
5.
6.
LM315GC
Handling Instructions
Page 4-36
Cutting Work