Baroness LM2700, Service Manual

Page: 215 / 325

1 Bolt
2 Cam
3 Boot
4 Lever
5 ID seal
6 Retainer
7 Stainless ball
Remove the torque plate assembly A and
the flat spring.
1
2
dwjhmx-003
Removal of Caliper_003
1 Torque plate assembly A
2 Flat spring
Remove the bolts, and then remove the
brake pad assembly and the torque plate
assembly B.
1
2
3
3
dwjhmx-004
Removal of Caliper_004
1 Brake pad assembly
2 Torque plate assembly B
3 Bolt
4.
5.
Installation of Caliper
Caution
See "Tightening torques" (Page 3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Make sure that the stainless ball is located at
concave of the inside and outside cams.
Important
The thrust bearing must be installed in
predetermined direction.
Make sure that the side with resin coating is
facing the side of the flat washer.
For installation, reverse the removing
procedure.
Removal of Front Wheel Mounting Base
Remove the front wheel. (See "Removal of
Front Wheel" (Page 7-18) .)
Remove the caliper. (See "Removal of
Caliper" (Page 7-20) .)
Remove the cotter pin.
1
2
sk4e7l-001
Removal of Front Wheel Mounting Base_001
1 Cotter pin
2 Wheel mounting base
1.
2.
3.
Main
bo
dy
LM2700
Main body
Page 7-21 Removal and installation of each section