Baroness LM2700, Service Manual

Page: 212 / 325

Removal and installation of each
section
Wheel
Removal of Front Wheel
Securely place the jacks beneath the jack-
up points of the front left/right frame area,
and then raise it until the tire lifts off the
ground. (See "Jack-up Points" (Page
3-10) .)
Remove the six bolts used to install the
front wheel.
1
2
oprpbl-003
Removal of Front Wheel_001
1 Front wheel
2 Bolt
Remove the front wheel from the wheel
mounting base.
1
2
3
oprpbl-004
Removal of Front Wheel_002
1 Wheel mounting base
2 Front wheel
3 Disc brake
1.
2.
3.
Installation of Front Wheel
Caution
See "Tightening torques" (Page 3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
For installing it, reverse the removing
procedure.
Removal of Rear Wheel
Caution
After jacking up this machine, fix this machine
with the jack stand.
Securely place the jack beneath the jack-up
points of the rear left/right wheel area, and
then raise this machine until the tires lift off
the ground. (See "Jack-up Points" (Page
3-10) .)
Remove the six bolts, spring washers and
washers used to install the rear wheel.
1
2,3,4
jnpvbf-003
Removal of Rear Wheel_001
1 Rear wheel
2 Bolt
3 Spring washer
4 Washer
1.
2.
LM2700
Main body
Page 7-18 Removal and installation of each section