8
2.Inspection before use
Greasing
The transmission and intermediate transmission gears are equipped
with needle bearings. Grease them every 10 hours. Shortage of grease
will cause damage to the needle bearings.
Inspection of engine oil
Replenish the engine with engine oil. (A correct level will be shown when the engine is
placed horizontally.) Change engine oil 8 hours after the initial operation, and every 50
hours from the second time onward. Oil : SAE30.
Inspection of wire
Check that the clutch wire and brake wire are normal.
3. Fastening of each portion
Many parts are fastened by bolts. Bolts and nuts may be loosened some time after initial
operation. Fasten them to the specified torque.
2-1
2-2
2-3
M6
M8
M10
M16
Normal bolt
8（80）
18（180）
36（360）
1.5-pitch left-hand thread: 36（360）
Heat treated bolt
36（360）
72（720）
4.Engine starting sequence
Before starting engine
Carefully read the gasoline engine operation manual before starting the engine. The
handle cover is equipped with an engine switch. Check the "ON/OFF" positions. Set the
engine switch lever in the ON position, set all moving parts in the neutral position. Check
for safety - covers are in position and not damaged and there is no person around the
machine - before starting the engine. Do not start the engine indoors without an
appropriate ventilator.
Starting the engine
1) Do not grip the main clutch lever.
2) Set the throttle lever in the high-speed
position.
3) Set the engine switch in the ON position.
4) Set the strainer lever in the open position.
5) Pull the choke lever and pull the recoil starter, and the engine will start.
6) Return the choke lever.
4-1
Appropriate fastening torque N.m (kgf-cm)
WARNING
10h
4-2
CAUTION
High-speed
OFF
ON
Open
Main
Clutch lever