Changing height of cut
First of all make sure that the height of cut range is correct as explained above.
You can now see that the bolts have been
inserted into their new position of ‘top left and
middle right’. If you refer back to the height
chart decal you will see that this now puts this
deck into the lowest range of 20 to 56mm.
To adjust the height of cut, first of
all loosen all three height
adjustment s shim retaining nuts.
It
is important to loosen all three nuts
at once and not try to adjust one
bracket at a time.
Trying to adjust
one bracket at a time will make the
task very difficult as it will have the
effect of trying to twist the deck.
Once all three nuts are loose,
remove shims in order to achieve
the desired pattern as stipulated on
the height range decal. If you need
to increase the height of cut you will
need to remove shims from above
the bracket and replace them below
the bracket. To decrease height,
remove them from below the
bracket and replace them above the
bracket.
