Baroness GM1700, Owner'S Operating Manual

Page: 57 / 87

Cutting Work
Cutting Operation
Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Caution
All persons other than the operator must keep
a safe distance from the machine.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Start the engine.
"Procedure to Start Engine" (Page 4-16)
Depress the brake pedal to release the
parking brake.
Shift the throttle lever to the "High speed"
position to run the engine at the maximum
rpm.
Shift the mower deck up/down switch to the
"DOWN" position to lower the mower decks.
Slowly set the knife rotation lever to the
"Rotation" position to rotate all rotary knives.
Depress the traveling pedal to start cutting
work.
Note:
While operating on a slope, adjust the angle of
the seat for better comfort.
Transporting
Transporting Procedure
When loading the machine into a trailer or a
truck to transport it, drive the machine forward.
When unloading, drive the machine in reverse.
If the roof is installed on the machine, remove
it.
The roof may be damaged by wind pressure.
1.
2.
3.
4.
5.
6.
Storage
Long-Term Storage
Follow the instructions below for long-term
storage of the machine.
Cleaning
Remove dirt, grass clippings, oil stains etc.
completely from the main vehicle and
engine.
Replacing oil
Inspect and replace the engine oil,
hydraulic oil and element.
Greasing and lubricating
Supply oil and apply grease to appropriate
parts.
Battery
Remove the negative battery wire.
Fuel
Remove the fuel from the fuel tank.
Tire pneumatic pressure
Set the tire air pressure slightly higher
than normal, and then place the machine
on a board to avoid humidity.
Mower decks
When storing this machine, lower all the
mower decks unless a positive mechanical
lock is provided.
Storage location
Cover the machine and store it in a dry
place where it will not be exposed to rain.
1.
･
2.
･
3.
･
4.
･
5.
･
6.
･
7.
･
8.
･
Handling Instructions
GM1700
Handling Instructions
Page 4-29
Cutting Work