Turn to the Mounting and Utility Connections
section of this manual for mounting instruc-
tions.
Three Holder B-pure (Three Water
Treatment Cartridges)
A common configuration built from B-pure
components is a Three-Holder System. This
system will utilize three water treatment car-
tridges in series. This will require a Dual
Holder and a single holder B-pure (D4511)
Disassemble the unit as follows:
1.
Position Dual Holder on right and sin-
gle holder on left on top of table.
2.
Remove the canisters from all units.
3.
Drive up fastener pins from the outlet
of the single holder and the inlet of
the dual holder and remove end fit-
tings. This is accomplished by gently
tapping from the bottom with a small
screwdriver and a hammer — exces-
sive force will damage the pins.
4.
Connect the two units together using
the head interconnector supplied.
Ensure that the o-ring is present in
both openings. Install and seat fasten-
er pins.
5.
Turn to the “Mounting and Utility
Connections” section of this manual
for mounting instructions.
21
M
AINTENANCE AND
S
ERVICING
Note
Refer to Figure 2 for assembly
order.
