background image

EXSTREAMER

100

Quick Install Guide  
Version 2.0

Mulitformat IP Audio Decoder

Package contents

Exstreamer 100

b  Power supply

RCA Stereo cable

Cable Set AUDIO 

(not included)

d Earphone

RCA Stereo cable

Network cable

g  Serial cable

Firmware

This device comes preloaded with standard firmware.
Alternative firmware can be downloaded from www.barix.com.

Support

For support please contact your local dealer or visit www.barix.com.

© Barix AG 3/2013, all rights reserved. All information is subject to change without notice. All mentioned trademarks belong  
to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland,  
and are registered in certain countries.

Summary of Contents for Extreamer 100

Page 1: ...omes preloaded with standard firmware Alternative firmware can be downloaded from www barix com Support For support please contact your local dealer or visit www barix com Barix AG 3 2013 all rights reserved All information is subject to change without notice All mentioned trademarks belong to their respective owners and are used for reference only Barix Exstreamer and SonicIP are trademarks of Ba...

Page 2: ...ts F RS 232 serial port DSub 9 pin male Pin Description 1 Not connected 2 Receive Data RxD 3 Transmit Data TxD 4 V 12V 100mA max 5 Ground GND 6 Not connected 7 Ready to Send RTS 8 Clear to Send CTS 9 Not connected Pin 4 will provide 2 6V less than the supplied voltage on Vin H but not more than 12V Rear view G LAN port 10 100 RJ45 Ethernet socket Pin Description 1 Tx 2 Tx 3 Rx 4 Not connected 5 No...

Page 3: ...evice see label on the bottom of the device Now that you know the IP address proceed to the next section Network configuration by web browser If you were not able to obtain the device s current IP address with the previous steps see section Troubleshooting 2 Network configuration by web browser Most Barix applictaions require no configuration but use DHCP to configure network settings dynamically ...

Page 4: ...trative rights to be able to do so sudo on OSX Linux STEP 5 Now we have to make the Exstreamer listen to the IP address 192 168 0 6 using the Telnet command To do so type into the command window telnet 192 168 0 6 1 and hit the Enter key the number one must be there for this command to work correctly The Exstreamer will immediately refuse the connection on port 1 but will be available for browser ...

Reviews: