STEP 1
Plug a standard (straight) network cable (h, not included)
into the network port (C) of the Exstreamer and the
other end into your hub or switch. You can also use a
crossover network cable (not included) for a direct
connection to your PC.
STEP 2
i) Plug standard headphones or the earphone (f, not
included) into the headphone output (4) and listen.
or
ii) Plug the RCA cable (c) into the LINE OUT outputs
(A) and connect the cable to inputs of your mixing
console or monitoring device and listen.
STEP 3
Connect the Power supply (b) to the device (socket D)
and then to an appropriate electrical outlet.
STEP 4
The Exstreamer will now search for a DHCP server to
get an IP address and announce it over the audio outputs
as well as display it on the LCD screen.
Example:192.168.0.12 (Voice: one nine two…)
Make sure you write this IP address down. Proceed to
section “2 Network configuration by web browser”.
If you do not have a DHCP server running on your
network you will still be able to configure the Exstrea-
mer. This will involve assigning an IP address to the unit
using one of 3 methods:
ARP (see section 4 of this guide), Telnet, or a serial cable:
refer to the manual for these procedures.
Troubleshooting
If no DHCP server is found then our IPzator function
will search the network for a free IP address (this could
take up to 5 minutes). If the IP address is not announced
check if the right hand LED of the network port (C) is
lit green. If it stays dark check your network cabling.
If the front LCD (3) stays dark check the power cabling
(step 3).
If still no IP address has been announced, revert the
device to its factory default settings by pressing the
Reset button for about 10 seconds while the device is
powered.
STEP 1
Open your web browser.
STEP 2
Enter the IP address that was announced by the Ex-
streamer and press Enter. Example: 192.168.0.12
In the top menu click on the “Configuration” button.
In the left menu click on “Advanced Settings”.
STEP 3
Enter an IP address into the 4 IP address fields. At default
it is 0.0.0.0 for automatic discovery (BootP, DHCP).
STEP 4
In normal operating conditions leave the Netmask as is.
STEP 5
The Gateway, primary and alternative DNS IP addresses
as well as Sonic IP can be left at default for now.
STEP 6
Hit the Apply button to save all changes. The Exstreamer
will reboot with the Static IP address. Please continue
with section “5 Next steps” on the last page.
3
Infared remote control
STEP 1
Insert the batteries (e) into the remote control (d),
observing the polarity requirements.
STEP 2
Read the firmware user manual for information about
configuration of the IR sensor and the supported
functions of the IR remote control.
1
Installation
2
Network configuration
by web browser