56-101-01175 Revision P Page | 18
5. PNEUMATIC PRESSURE CONNECTIONS
A.
Pitot & Static Quick Disconnect Ports
(Standard Configuration, refer to Figure 10)
1. Pitot (Pt)
– P/N B-QC4-D-2PMK5FV
2. Static (Ps)
– P/N B-QC4-D-2PMK2FV
Note
: OPT A includes AN4 fittings in both ports Pt (pitot) and Ps (static), P/N 284-00013
Figure 10
DPS1000 Pressure Connections
B.
Blanking Caps
(Used on OPT A only)
When not in use, the panel mounted blanking caps should be fitted to the ports to prevent
the introduction of any foreign matter.
Do not use a wrench when connecting Blanking Caps to the Test Set’s Static (Ps) and
Pitot (Pt) ports
– hand-tighten only (refer to Figure 11).
Note:
During the performance of a leak test of the Test Set, a leak at these AN4 caps will
adversely affect the outcome of the test.
Figure 11
O-Flared Ports
2
1