English
Site~Rite* IV Ultrasound System Operator’s Manual
MaterialSafetyData
2.1 Standoff Probe Fluid
Warning:
Contains n-Butyl Phthalate (C
16
H
22
O
4
): Causes eye irritation. May cause skin irrita-
tion. Inhalation of high vapor concentrations may be harmful. Avoid contact with eyes,
skin and clothing. Avoid breathing vapors. Use with adequate ventilation. Keep container
closed. Wash thoroughly after handling. Ingestion of large quantities may cause liver or
kidney damage.
Protective Equipment: Wear impervious gloves and eye protection. Provide adequate ventilation.
First Aid
Inhalation – Remove from exposure area to fresh air immediately. If breathing has stopped, give
artificial respiration. Keep affected person warm and at rest. Get medical attention.
Skin Contact – Remove contaminated clothing and shoes. Wash affected area with soap or mild
detergent and large amounts of water until no evidence of chemical remains (approximately 10 – 20
minutes). Get medical attention if necessary.
Eye Contact – Wash eyes immediately with large amounts of water, occasionally lifting upper and
lower lids until no evidence of chemical remains (approximately 15 – 20 minutes). Get medical atten-
tion.
Ingestion – If victim is conscious, immediately give 2 to 4 glasses of water and induce vomiting by
touching finger to back of throat. Get medical attention immediately.
Supplied To: Bard Access Systems, Inc., Salt Lake City, UT 84116 U.S.A. www.bardaccess.com
Phone: (801) 595-0700
Supplied By: Fisher Scientific, 2000 Park Lane, Pittsburgh, PA 15275 U.S.A.
Phone: (412) 460-8300
SettinguptheSite~Rite
*
IVSystem
Unpack the Site~Rite IV System and verify the contents against the packing slip.
3.1 Assembling the Roll Stand
The roll stand requires some assembly before use.
Assembling the roll stand consists of three tasks:
•
Attaching the base to the post.
•
Attaching the wire basket.
•
Attaching the side arm.
Tools Required
•
3/16 inch Allen wrench
•
1/2 inch open (or box) wrench
•
#2 Phillips head screwdriver
Attaching the Base to the Post
To attach the base to the post,
1. Place the base on its side.
2. Slide the post into the center of the base.
3. On the wheel caster side of the base, place the 2" washer over the center of the base. Align
the post hole and the washer hole.
4. Use the open wrench to screw the inch-long bolt through the washer and into the post.
5. Tighten the bolt.
6. Position the roll stand upright so that it rests on its wheel base.
Note:
Two of the wheel casters have wheel locking levers that you can flip down to prevent the
Chapter 2: Material Safety Data, Chapter 3: Setting up the Site~Rite* IV System
Summary of Contents for Site-Rite IV
Page 2: ...Site Rite IV Ultrasound System Operator s Manual...
Page 3: ......
