Barco XDX Series, Installation Manual

Page: 42 / 90

R5914481 /02 XDX 42
4.1 Accessing the power connections
CAUTION: Whenever you access the mains board and thus remove the net input cover, make sure
the projector is disconnected from the power net.
Required tools
Torx screwdriver T20
How to access
1. Remove the back and power side cover of the projector.
2. Slightly loosen the two screws on the bottom of the net input cover (reference 1, Image 4–1 ). Use a T20
Torx screwdriver.
3. Lift the net input cover up and away from the projector.
1
Image 4–1 Removal of the net input cover
4.2 Power input configuration of the projector
About the power input.
The power input of the projector can be configured in one of three different configurations, depending on the
local power supply:
• In a Y configuration (3W+N+PE) for a three phase power supply of 200-240 V / 346-415 V. In this
configuration, 346-415 V is measured between the lines while 200-240V is measured between the lines
and the neutral.
• In a Δ configuration (3W+PE) for a three phase power supply of 200-240 V. In this configuration, 200-240
V is measured between the lines.
• In a mono phase configuration (L1+N+PE) for a mono phase power supply of 200-240 V. In this
configuration, 200-240 V is measured between L1 and the neutral (N) or L2.
Before operating the projector, place the links in the correct position depending on the local power supply.
Installation procedures