![background image](http://html.mh-extra.com/html/barco/xdl-series/xdl-series_installation-manual_474397107.webp)
R5906150 /02
XDL
107
1
Image 10-1
3.
Press the
Power on/off
button on the projector, or the
Power On
button on the remote control. The projector
will continue to operational mode. The
Power on/off
button will blink BLUE until the projector is ready
(reference 2, Image 10-2). In this process the shutter will close and the
Shutter
button will be lit RED. The
start up screen is displayed on the LCD display and when fully started up, it changes to the overview screen.
Once the projector is ready & conditioned, the Power on/off button will be lit BLUE. Now the lasers are active
and light can come out of the projector. The shutter however remains closed. While the shutter is closed, the
lasers will be set to minimum power.
1
2
Image 10-2
4.
Press the
SHUTTER
button on the Local Keypad, remote control or use the Projector Toolset to open the
shutter.
Status overview
Once the projector is started, press the
Menu Activation
button to get an overview of parameters such as :
•
Device serial number and article number
•
Current firmware version and model name
•
Current illumination (in percentage)
•
Projector runtime in hours
•
Uptime in hours
•
Chosen source
•
Current resolution and refresh rate
•
Chosen communication method and IP address (if connected)
•
Active functions
Starting image projection
1.
Make sure the available sources are connected to the appropriate input ports.
Tip:
If properly connected, the
“
SYNC
”
LED will light up ORANGE.
2.
Press the
Input Selection
button on the keypad or on the remote control until:
•
the LED of the selected source (the
“
SEL
”
LED) light up GREEN, and
•
the image of the selected source is projected.
Summary of Contents for XDL Series
