1. Safety
1.3
Important safety instructions
Instructions:
•
Read these instructions.
•
Keep these instructions.
•
Heed all warnings.
•
Follow all instructions.
•
Clean only with materials or chemicals that are inert, nonabrasive, noncorrosive and non-marking. Consult the manufacturer
for further advice should any doubts exist regarding any cleaning procedure.
•
Do not block ventilation openings. Install in accordance with the manufacturers instructions.
•
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampli
fi
ers) that
produce heat.
•
Do not defeat the safety purpose of the polarized or grounding type plugs/sockets. If the provided sockets/plugs are damaged
then replacement of the defective parts must be undertaken immediately.
•
Protect the power/data cords from being walked on or pinched particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus. Replace damaged power/data cords immediately.
•
Only use attachments/accessories speci
fi
ed by the manufacturer.
•
Disconnect the power to this apparatus during lightning storms or provide suitable additional lightning protection. Unplug this
apparatus when unused for long period of time.
•
Refer all servicing to quali
fi
ed service technicians/personnel. Servicing is required when the apparatus has been damaged in
any way, such as power-supply cord or plug is damaged, the apparatus does not operate normally, or has been dropped.
•
Use only with systems or peripherals speci
fi
ed by the manufacturer, or sold with the apparatus. Use caution during lifting/moving
or transporting to avoid damage by possible tipping.
•
Do not use damaged LED tiles. Replace damaged parts immediately. Ensure that the spring of each locking mechanism (latch)
is functioning properly. If not, replace immediately.
1.4
Important warnings
Important warnings:
Risk of electric shock:
Do not open. To reduce the risk of electric shock, do not remove LED board from tile. No user-serviceable parts inside. Refer
servicing to quali
fi
ed service personnel.
Maximum and minimum ambient temperature:
The maximum ambient temperature for the LED wall is 40°C (104°F), the minimum temperature is -10°C (14°F).
Low Voltage Surge Protection Device required
Due to the damaging effects of lightning, utility switching and switching electric motors of other users on the mains, this product
needs to be protected by means of a Surge Protection Device. This product is connected to the mains through a power distribution
box from party, please verify that a Low Voltage Surge Protection Device according EN61643-11 or UL 1449 is in place.
High leakage current:
The combination of multiple tiles in an installation results in increased levels of leakage current. In order to avoid risk of electric
shock due to high leakage current, proper grounding of the installation is required.
Flammable materials:
Keep
fl
ammable materials away from the installation (such as curtains). A lot of energy is transferred into heat. The installation
should be such that the amount of air
fl
ow required for safe operation of the equipment is not compromised. Proper ventilation must
be provided.
Risk of electric shock / Risk of
fi
re:
Each power source cable should be protected by a circuit breaker or fuses rated 16 A / 250 VAC (15 A / 250 VAC in the USA and
Canada). Note that one tile requires 100-240 VAC, 50-60 Hz.
To protect against risk of
fi
re caused by overloading of power cables, the number of tiles connected in parallel is limited. See table
below.
Tile
Power source
Maximum number of tiles per power source cable
X 1.2
110-180Vac
180-240Vac
10 tiles
14 tiles
X 1.5
110-180Vac
180-240Vac
10 tiles
14 tiles
R5906876 X-SERIES 24/07/2017
3
