Barco ULC-30A, Service Manual

Page: 47 / 102

8. Primary pump unit
8.4 Installing the primary pump unit
Necessary tools
• Flat screwdriver
• Phillips screwdriver PH2
• Nut spanner 5.5 mm
• Nut spanner 8 mm
• Cutting pliers (for cable ties)
• Cable ties
• glue
This procedure assumes that power has been switched off. Unless otherwise stated, power must be off prior
to start with this procedure. To switch off power, see procedure "Switching off power and locking the switch",
page 15.
How to install the primary pump unit?
1. Mount the primary pump unit:
a) Tilt the front side of the primary pump unit inwards the left side of the chiller and move to the front for 10 cm.
Image 8-14
Installing the primary pump unit — step 1 of 2
b) Move the primary pump unit towards the rear of the chiller until the two screws at the rear of the chiller are engaged in the
slots of the primary pump unit base.
Image 8-15
Installing the primary pump Unit — step 1 of 2
2. Install the two screws (reference 1 image 8-16) (front side of the chiller) using the nut spanner 8 mm.
R5906015 ULC-30A 01/02/2018 43