![background image](http://html1.mh-extra.com/html/barco/udx-4k32/udx-4k32_user-manual_3869477032.webp)
4. Getting Started
Starting image projection
1. Make sure the available sources are connected to the appropriate input ports.
Tip:
If properly connected, the “SYNC” LED will lit up ORANGE.
2. Press the
Input Selection
button on the keypad or on the remote control until:
-
the LED of the selected source (the “SEL” LED) lit up GREEN, and
-
the image of the selected source is projected.
1
2
Image 4-3
4.3
Switching to standby
How to switch to standby
1. Press and hold the
Power on/off
button for 3 seconds on the local keypad, or press the
Power Off
button on the remote control.
The projector goes to standby mode. The after-cooling cycle will start (about 30 seconds). During this period the Power on/off
button will blink. Once the after-cooling cycle has ended, the projector will be in standby mode and the Power on/off button will
be lit WHITE.
30 s
3 s
Image 4-4
4.4
Power off projector
C
AUTION
:
This procedure assumes the projector is in standby mode.
How to power off
1. Switch off the projector with the mains switch. ’0’ must be pressed.
28
R5906112 UDX SERIES 24/05/2017
Summary of Contents for UDX 4K32
