![background image](http://html1.mh-extra.com/html/barco/udx-4k22/udx-4k22_installation-manual_3870620037.webp)
R5906113 UDX 07/07/2017
33
3. Physical Installation
3.3
Remote control, protocol setup
About the used protocol
The protocol is the code send out by the remote control when a button is pressed. Depending on this code, the projector can decode
the signals. The remote control can be used with two different protocols, RC5 and NEC. Depending on the projector to control the
remote control can be switched between these protocols.
Which protocol to use
•
The
NEC
protocol have to be used for Barco projectors based on the Pulse platform: F70, F80, F90, HDX 4K, UDX, ...
•
The
RC5
protocol have to be use all other Barco projectors: HDX W, HDF W, HDQ 2K, ...
How to set
1. Remove the cover. For more info on how to remove, see "Remote control, Battery installation", page 30.
2. Place the switch in the NEC position.
Image 3-5
Remark with RC5 protocol
Not all buttons of the Pulse RCU are one-to-one compatible with the legacy Barco RCU. Button pairs SHUTTER open/close and
POWER on/off emit the same code (per pair) when in RC5 mode, because the legacy RCU’s only had 1 button for Shutter and 1
button for Standby.
Summary of Contents for UDX 4K22
