Barco UDM, Installation Manual

Page: 74 / 106

R5911438 /09 UDM 74
5.4.5 Change the motor block orientation
The illustrations in this procedure are a single example, shifting the motor block rotation from UDX
left side projection to HDX/HDF left side projection (seen from the rear side of the projector in table
mount). Other examples are possible, but will use the same method.
Required tools
Allen wrench 2.5 mm.
Required parts
Set screw M5x8 DIN915.
Rotate the motor block of the lens
1. Remove the eight screws (reference 1) as illustrated. Use a 2.5 mm Allen wrench.
1
Image 5–27
2. Rotate the motor block around the lens body in to the desired position.
Image 5–28
3. Fasten the motor block with the eight screws which you have removed in step 1.
1
Image 5–29
4. Will the lens be installed on an UDX projector?
•
If yes, turn the set screw into the mounting plate until it exceed 1.5 mm on the other side of the
mounting plate.
Lenses