Barco Trace+ R9040341, Owner'S Manual

Page: 137 / 151

8. Service Mode
8.9.5 Hot Key
How to Change the Hot Key Setting?
1. Push the cursor key ↑ or ↓ to highlight
Hot Key.
(menu 8-25)
2. Press
ENTER
to toggle the Hot Key Setting [ON] or [OFF].
[ON] The
TEXT
key on the RCU is used to display or to remove the Barco Logo with one single push on this key
(only in operational mode)
[OFF] No key on the RCU is used to display the Barco Logo
3. Press
EXIT
to return to the
Service
menu.
BARCO LOGO
STATUS [OFF]
BACKGROUND [OFF]
SHIFT
HOT KEY [OFF]
Select with
↑
or
↓
<ENTER> to toggle/select
<EXIT> to return
Menu 8-25
8.10 Preset Input Balance 1
C
AUTION
:
Changing these settings may seriously affect the performance of the projector.
How to Start Up Preset Input Balance?
1. Push the cursor key ↑ or ↓ to highlight
Preset Input Balance
1. (menu 8-26)
2. Press
ENTER
to select.
The following warning will be displayed: (menu 8-27)
Preset input balance is reserved to qualified service personnel. If you are not qualified, press
EXIT
to return to the
Service
menu.
SERVICE
BARCO LOGO
PRESET INPUT BALANCE 1
PRESET INPUT BALANCE 2
ELECTRONIC CONVERGENCE
DIAGNOSIS
DYNACOLOR
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 8-26
WARNING
PRESET INPUT BALANCE
is reserved to
qualified
service personnel
<ENTER> to continue
<EXIT> to cancel
Menu 8-27
8.11 Preset Input Balance 2
C
AUTION
:
Changing these settings may seriously affect the performance of the projector.
R5976781 TRACE+ 14/09/2004 133