BARCO 1
Projection Systems
TLD(2.8-5.08):1 Lens R9840690
What has to be
done
This new lens has to be installed on the SLM series projector
Necessary Tools
no tool necessary
To be continued on next page.
Warning !
Risk of personal injury. Instructions for lens installation must be followed thoroughly.
Installing the
Lens
To install the lens, follow the next procedure:
1
2
3
-
1&2
3
Take the lens assembly out of its packing material and
remove the lens caps on both sides.
Move the handle (A) of the lens anchor system to the right.
Push the lens, motors at the top, in the lens block gap
horizontally, lining up the motor connector on the lens with
the connector on the lens block (B), until the lens clicks in
the lens anchor system.
Attention
: for a table mounted projector, hold the projector
when pushing the lens into the lens block to
avoid sliding
off from the table
.
Step
Action
Image
Illustrations
Image 1
Image 2
A
Image 3
B
