Barco Thor, User Manual, Page: 39 / 76

5. ICMP
3
GPI 1-4 (5-8)
These RJ45 connectors can be used to receive trigger signals from other devices. The mapping of the General Purpose
Input (GPI) on each input Cues is con
fi gured via the Communicator software. Please refer to the Communicator user
guide for further information.
4
SYNC IN / OUT
Synchronization signal IN and OUT: Reserved for multiple-projector projection. Use a 50 Ohm coaxial cable to connect
the sync signal from projector to projector.
5
LAN 1 (2)
The ICMP can be connected to a LAN (local area network) using one of the Ethernet ports. These LAN port are used
for ‘content’ transfer.
NOTE : These ports are optionally used to connect to external content storage sources. Control of the ICMP is done via the
same IP address as the projector.
6
USB 2.0
The ICMP can be connected to a USB 2.0 Media to load content. The USB port can be used to load content (DCP) or
keys (KDM).
NOTE : It is recommended to use the USB 3.0 ports for faster ingest.
7
USB 3.0
The ICMP can be connected to a USB 3.0 Media to load content. The USB port can be used to load content (DCP), or
keys (KDM), or software update.
NOTE : These ports are recommended for fast ingest when connected to an appropriate USB 3.0 source.
USB
Universal Serial Bus (USB) is an industry standard developed in the mid-1990s that de fi nes the cables, connectors and
communications protocols used in a bus for connection, communication, and power supply between computers and
electronic devices.
USB 2.0 (also called "Hi-Speed"), adding higher maximum signaling rate of 480 Mbit/s (effective
throughput up to 35 MB/s or 280 Mbit/s), in addition to the "USB 1.x Full Speed" signaling rate of 12 Mbit/s.[16] USB 2.0
connectors are usually colored black.
USB 3.0 de fi nes a new SuperSpeed mode with a signaling speed of 5 Gbit/s and
a usable data rate of up to 4 Gbit/s (500 MB/s). A USB 3.0 port is usually colored blue, and is backwards compatible
with USB 2.0.
5.4 ICMP source input ports
Location of the source input ports
The last produced model is equipped with two HDMI 2.0 (Reference 8, image 5-8) as video source.
8 9
Image 5-8
ICMP (with HDMI 2.0).
Some models with DisplayPorts (Reference 11, image 5-9) and HDMI 1.4 (Reference 10, image 5-9) are still present on the fi eld.
R5906787 THOR 26/01/2018 35