SDI-DMX Mixer Pro User Manual
4
Connecting to Communication Interface
The SDI-DMX Mixer Pro can accept DMX Controller commands or RS232
commands.
NOTE: Only one signal type should be used at any one time. Connection
and transmission of both signal types may result in erratic
behaviour.
You can set a DMX Start Channel for the unit using the menu system. See
AddR (Address)
on page 6.
Connecting to the DMX 512 link
The DMX512 control is connected by the 5-pin XLR connectors on the rear
of the unit. The unit features a DMX in and DMX through port for connection
to other devices. Plug in the DMX cable and also the DMX Thru cable if
required.
Connecting the RS232 Interface
The unit features an RS232 serial port for computer control and system
integration. This is connected via the D-Type connector on the rear of the
unit.
Connecting to Power
Power for the units is supplied in the form of a plug-top mains adapter or
inline mains "brick". This is an auto-ranging unit and can be used with any
mains voltage.
The low voltage DC connector plugs into the power connector on the rear of
the unit and secures by means of a screw thread.
CAUTION! Always unscrew the connector before
attempting to remove it! Failure to do so may result in
damage to the connector, mains adapter or unit.
Original PSUs must be used with these units. Using a
non-OEM PSU may result in damage to the unit and will
void the warranty. PSUs may be ordered from your
local distributor.
