Barco REALITY 8200LC R9001218, Owner'S Manual

Page: 11 / 59

3-1
Location and Functions of Control
5975848A BARCOREALITY 8200LC 170698
3
RS 232 IN
REMOTE
PROJECTOR MODE :
GREEN - OPERATION
RED - STANDBY
COMMUNICATION PORT
(800-PERIPHERALS)
RS232 OU T
IR-ACKNOWLEDGED
IR-RECEIVED
DIAGNOSTICS
CODE IR-RECEIVER
9
$
+]
0 I T h i s d e v i c e co m p l i e s w i t h P a rt 1 5 o f t h e F C C r u l e s . O p e r a t i o n
i s s u b j e c t t o fo ll o w i n g t w o c o n d it i o n s :
( 1 ) T h is d e v i c e m a y n o t c a u s e h a r m f u l i n t e r f e r e n ce
( 2 ) T h is d e v i c e m u st a c c e p t a n y in t e rf e re n c e r e c e iv e d
i n c l u d i n g in t e rf e re n ce t h a t m a y c a u s e u n d e s i re d o p e ra t i o n
LOCATION AND FUNCTIONS OF CONTROL
Front Panel Terminology
IR-Received : IR signals are received but not recognized
by the projector.
Diagnostics code : a) source number
b) error code : a two digits error code is displayed when
something goes wrong inside the projector.
IR receiver : receiver for control signals transmitted from
the RCU.
Power switch : '1' = on, '0' = off
Power input : autoranging from 200 to 240 Vac.
Identification plate : name, serial number, art. number.
Voltage identification plate : name, art. number.
1
2
3
RS232 IN : to allow communication with external compu-
ter, e.g. IBM PC or compatible, Macintosh ...
RS232 OUT : used to connect to next projector, RS232IN
plug (communication link for PC or MAC to the next
projector).
Communication port : allows communication with the
800 peripherals.
Remote : remote input for wired remote control.
Projector mode indication : indicates the status of the
projector.
Light off : power switch is not pressed.
Red light : power switch is pressed, projector in
stand by mode.
Green light : projector in operational mode.
IR-Acknowledged : IR signals are recognized.
4
5
Control Panel Terminology
a. Local keypad
Gaining access
6
7
8
9
10
11
12
The keypad is located behind a door, screened with the name
of the projector.
To open the door, push once on the indicated side of the door
and turn it to the front side of the projector.