Barco R9806700, Installation Manual

Page: 73 / 105

14. ACSAR Set Ups
• Unique address: differ from “0” and “1” and is specific for that unit. The ACSAR execute the commands from the Remote
Control if the latter is programmed on the same unique address.
Controlling ACSAR
With Remote Control used addresses 0 up to 9
With Computer e.g. IBM PC (or compatible), Apple,MAC,
etc... used addresses 000 up to 255
• Common address: only 2 values are possible “0” or “1” (adjustable). The ACSAR execute the commands from the Remote
Control if the latter is programmed on the same common address.
Storing the individual address
1. From the Service menu, select item
CHANGE PROJ. ADDRESS.
(menu 14-12)
The Change Projector (=ACSAR) Address menu appears on-screen and in the graphical display. This menu displays the already
stored addresses, common and unique. (menu 14-13)
2. Select the ACSAR Address item press ENTER or selection wheel to confirm.
The first digit in the address number, composed of 3 digits, is active and ready to be changed.
3. Enter the new address number as follows:
- With the Remote Control: successively enter with the numeric buttons a new number. Terminate number entry by PRESSING
SELECTION WHEEL on ACSAR (Remote Control becomes inactive after the address change and has to be reprogrammed
on the new address, if between 0 and 9)).
- With the selection wheel: rotate selection wheel to change the digit and press wheel to jump to next digit. Terminate number
entry by pressing selection wheel.
The new value is stored or if an incorrect value has been putted in, a message ’Invalid Address’ is displayed indicating the correct
value range. (menu 14-14)
4. Press EXIT (RCU) or select item RETURN with selection wheel on ACSAR to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
MORE....
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
0HQX
CHANGE ACSAR. ADDRESS
ACSAR ADDRESS 5
COMMON ADDRESS 0
Select with
↑
or
↓
then <ENTER>
Reprogram with
↑
,
↓
,
←
,
→
or numeric keys
<ENTER> to confirm
<EXIT> to return
0HQX
ERROR
Installed Address
The ACSAR Address
is a number between
0 and 255
<EXIT> to return
0HQX
Storing the common address
1. Select the Common Address item and press ENTER or selection wheel to confirm. (menu 14-15)
The address digit is active and ready to be changed.
2. Enter the new address number as follows:
- With the Remote Control: enter with the numeric buttons a new number. Terminate number entry by pressing ENTER .
- With the selection wheel: rotate selection wheel to change the digit and press wheel to terminate
The new value is stored or if an incorrect value has been putted in, a message ’Invalid Address’ is displayed indicating the correct
value range. (menu 14-16)
3. Press EXIT (RCU) or select item RETURN with selection wheel on ACSAR to return.
CHANGE ACSAR. ADDRESS
ACSAR ADDRESS 5
COMMON ADDRESS 0
Select with
↑
or
↓
then <ENTER>
Reprogram with
↑
,
↓
,
←
,
→
or numeric keys
<ENTER> to confirm
<EXIT> to return
0HQX
ERROR
Installed Address
The common Address
is a number between
0 and 1
<EXIT> to return
0HQX
R5976519 ACSAR 12122002 69