Barco R92112011, User Manual

Page: 67 / 210

7. Advanced
7.4.2 Auto Image
What can be done ?
Auto Image creates the best suited image fi le for the connected source.
It calculates/measures several source parameters :
• Total pixels per line
• Start pixel
• Phase
• Contrast/Brightness levels
Auto Image only works for data images.
The measure of the total number of pixels per line can be done through 2 methods
• Limited scan: a windowing system is used to allow fast tracking.
The operation takes about 20 seconds (depending on
fi le)
• Full scan: tracking is done over the full range.
The operation takes about 1.5 minutes (depending on
fi le)
How to launch Auto Image?
1. Press MENU to activate the Tool bar
2. Press → to select the Image fi les item
3. Press ↓ to Pull down the Image fi les menu
4. Use ↑ or ↓ to select Auto Image
5. Press → to open the menu
6. Use ↑ or ↓ to select the desired fi le scan method
Image 7-24
7. Press ENTER
Auto Image acts on the active window. The image in the window may move and change in aspect during the
Auto Image process.
Auto Image can also be launched via the RCU with the dedicated Auto Image key.
7.4.3 Edit fi le
What can be done with the Edit fi le menu ?
The Edit fi le menu makes it possible to change the settings of the fi le according to the real settings of the connected source. Consult
the source speci fi cations before entering the data.
R59770066 SIM 7Q SERIES 08/12/2014 63