4. Getting Started
When switching to standby, it takes 15 seconds before the projector can be switched on again.
4.6
Switching off
How to switch off the projector?
1. Press
fi
rst
Standby
.
2. Let cool down the projector until the fans stop blowing, at least 15 min.
3. Switch off the projector with the power switch.
4.7
Using the RCU
Pointing to a re
fl
ective screen.
1. Point the front of the RCU to the re
fl
ective screen surface. (image 4-3)
F1F2F3F4
F5
ADJ
EXITENTER
PAUSEPHASETEXTSHARPNTINT
COLORBRIGHTNCONTR
TREBLEBALANCEBASSVOL
90
7
8
5
6
34
1
2
Remote Control (A)
Screen (B)
IR sensor (C)
Image 4-3
Pointing RCU to the screen
When using the remote control, make sure you are within the effective operating distance.
The operating distance may be up to 15 m (50ft).
The remote control unit will not function properly if strong light strikes the sensor window or if there are
obstacles between the remote control and the IR sensor.
R5976690 XLM H25 25/05/2009
41
Summary of Contents for R9010100
