![background image](http://html.mh-extra.com/html/barco/r9004200/r9004200_installation-manual_473785035.webp)
4. Servicing
4. SERVICING
4.1 Safety instructions
Personal Protection
Image 4-1
Warning
Image 4-2
Suspended Loads
Image 4-3
Hard Hat
Image 4-4
Mind Your Fingers
Be aware of suspended loads, wear a hard hat to reduce the risk of personal injury. Mind your fingers while working with heavy
loads.
Safety precautions
•
Fence off a restricted area of at least 3 meters around the LED-wall using an eye-catching fence and “KEEP OUT” signs. This
to prevent unauthorized persons come near the LED-wall during servicing.
•
Inspect the complete LED-wall for security, wear, deformation, corrosion, and any other circumstances that may effect the load
handling capability of the part.
•
Check the handles on the back of the tiles for loss of strength due to exposing to environmental conditions. Replace damaged
handles immediately before starting any servicing to the tiles.
•
Ensure that each tile is secured with a safety cable to the LED-wall structure.
•
Do not modify and/or replicate any component. BARCO uses specific materials and manufacturing processes in order to
achieve part strength. No other parts then BARCO parts are allowed.
4.2 Removing a SLite tile
What has to be done ?
Removing an installed SLite tile from the LED-wall in a secure manner. This can only be done via back and front access at the same
time. At least three qualified persons are required to get the job done. Two persons at the front and one at the rear of the LED-wall.
The following procedure must be performed by minimum three authorized and qualified technical persons,
which are thoroughly familiar with the product and all of the proper safety checks of this product. To do
otherwise increases the risk of hazard and injury to the user.
Necessary tools
•
Scaffold or Z-lift.
•
Wrench 13 mm.
•
Wrench 10 mm.
•
Hoisting crane.
How to remove a SLite tile ?
1. Read and heed the servicing safety instructions page 31.
2. Build a solid scaffold at the rear of the LED-wall or use a Z-lift to access the tile in case there is no frame provided to the rear of
the LED-wall with service access.
3. Build a solid scaffold in front of the LED-wall or use a Z-lift to access the tile.
Warning:
Both hands must be free for accessing a tile in a LED-wall. Therefor the use of a ladder to access a tile is forbidden.
Only a solid scaffold or a Z-lift is allowed.
4. Check if the tile is secured with a safety cable.
R5976575 FIXED SLITE DISPLAY 17102003
31
Summary of Contents for R9004200
