Service Mode
7-3
5975039 BARCOVISION 508 120198
Total Run Time
Highlight
'Total Run Time'
with the control disc and press
ENTER
to
display the amount of time the projector has played since its first start
up at the factory.
Note : all projectors leave the factory after a burn-in period of
approximately 100 hours.
Change password
This item is password protected.
Highlight
'Change Password'
with the control disc and press
ENTER
.
ENTER
gives the selected item.
EXIT
returns to the Service mode menu.
ADJUST
returns to the Operational mode.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
ENTER
will display the selected item.
EXIT
will return to the Path Selection main menu.
ADJUST
will return to the Operational mode.
The current password is displayed. The new password must
consist of 4 digits between 0 and 9. Push the control disc to the left
or to the right to select the digits to be changed. Use the numeric keys
to enter the new digits.
Press
ENTER
to save the new password. Before saving the new
password, a confirmation screen will be displayed.
Press
EXIT
to return to the Projector Set-up menu without saving the
new password.
When the displayed password is correct, press
ENTER
to save.
If not correct, press
EXIT
to cancel the saving.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
Use and to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
PASSWORD
Enter new password :
0 0 0 0
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
CHANGE PASSWORD
ENTER
saves the entered password.
EXIT
returns without saving.
Change Projector Address
Every projector requires an individual address between O and 255.
This address can be software installed.
To change that address, push the control disc up or down to highlight
'Change Porjector Address' and press
ENTER
. The Change Projector
Address menu will be displayed and the actual address will be filled
in.
Select with or
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
ENTER
displays the 'Change Projector Address' menu.
EXIT
returns to the Service mode main menu.
The first digit is highlighted. Select the individual digits by pushing the
control disc to the right or to the left. Reprogram with the digit keys
on the RCU.
Press
ENTER
to confirm.
Press
EXIT
to return to the projector set up menu.
<ENTER> to confirm
<EXIT> to return.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use and to select,
and reprogram
with numeric keys.
Highest address is 255
Downloaded from ProjectorsManual.com Manuals
