![background image](http://html.mh-extra.com/html/barco/r767302k/r767302k_instructions-manual_474433020.webp)
24-1701050-00 /01
EC-200 to EC-210 Conversion Kit
20
7.
Remove the Rear I/O plate along with the DVI and USB cables that are attached to it.
2.5 Installing EC-210 components
It is important
that you use room-temperature-vulcanizing (RTV) silicone to help secure some of
the motherboard connections, to prevent these connections from coming lose during transit. These
instructions will identify with a note those connections that may be stabilized with RTV silicone.
Required tools
•
Allen wrench 1/16 inch
•
Allen wrench 2 mm
•
Allen wrench 2.5 mm
•
Allen wrench 3 mm
•
Allen wrench 4 mm
•
Nut driver 5 mm
•
Nut driver 5.5 mm
•
Nut Driver 8 mm
•
Open-end wrench 5 mm
•
Phillips screwdriver PH1
•
Phillips screwdriver PH2
•
Pliers
•
Torx screwdriver T10
Rear I/O plate assembly
1.
Attach the Ethernet connectors, panel-mount USB cables, and panel-mount HDMI connector to the rear I/O
plate.
1.
Attach the Ethernet connectors, panel-mount USB cables, and panel-mount HDMI connector through the
inside of the rear I/O plate.
2.
Install the dual USB connectors with the open part of the connector on the bottom, as shown in Image 2-
12.
Image 2-12: Dual USB connectors on the rear I/O plate
3.
Screw in the Ethernet connectors, panel-mount USB cable, and panel-mount HDMI connector screws from
the outside of the rear I/O plate.
4.
Hold the nuts on the inside of the rear I/O plate with a pair of pliers (or use an adjustable wrench or a 5 mm
open-end wrench).
2.
Attach the power switch to the rear I/O plate.
1.
Insert the power switch assembly through the power-switch hole in the rear I/O plate from the outside face
(the face on the opposite side of the plate from the Ethernet board).
2.
Apply the retaining nut for the power switch on the inside of the rear I/O plate (the same side of the plate on
which the Ethernet board is attached).
3.
Tighten the retaining nut with an adjustable wrench (or an open ended wrench of the correct size) until
snug (about 4 to 6 inch-pounds).