18
PGXG-61B/PGWX-61B/PGWU-61B - - 2014/02/12
3. Installation
3.2 Installing the Lens
Turn the projector off and unplug the power cord.
1.
Allow the projector to cool down for at least 1 minute then start the lens
2.
replacement.
Remove the lens ring cover.
3.
1
Remove the lens cap counterclockwise.
4.
2
Pull the bar to release the lock.
5.
3
Be sure the label of lens is upward and then push the lens into the position.
6.
4
Rotate the lens clockwise to lock the lens while pull the bar
7.
3
to release the lock.
5
Put the lens ring cover back to its place. Push rubber fingers over lens edge.
8.
6
To replace the lens module, reverse the previous steps.
9.
Lens cap should be removed before installing. If not it will damage the projector.
10.
Procedure:
1
5
6
2
3
4
Warning: This procedure may only be performed by qualified technical service personnel.
Caution: Do not transport the projector with any lens installed.
