Barco NW-12, User Manual, Page: 133 / 181

7. Advanced
Image 7-133
The common color values are automatically calculated based on the measured values of both projectors and these calculated
values are put in the
Desired values of both projectors. Both projectors will now operate within the same color gamut.
Link Set can only be performed if the linked CLO has been enabled, see Linked Projectors .
7.9.6.3 Black Color Matching
Overview
• Introduction
• Black Color adjustment for Set 1
7.9.6.3.1 Introduction
Black Color uniformity
In a multi channel system the color of “black” can differ over the different channels/projectors. This can be matched using the Black
color matching function. This function allows to adjust the Red, Green and Blue contribution to the black color produced.
In the same way as for the Dynacolor, this adjustment can be done for Set 1 and Set2
The procedure below is done for set 1.
R59770286 NW-12 25/09/2008 129