Barco Nio MDNC-3521 SNES, User Manual

Page: 34 / 66

R5915130 /05 Nio 2MP / 3MP LED Display 34
3. Select DICOM Calibration to start the calibration.
Warning: Press and hold the jog dial for approximately 3 seconds during calibration will abort the
calibration, previous values will be restored.
Note: After calibration, the compliance check will start automatically.
4.15.4 DICOM error threshold
About DICOM error threshold
The threshold to define the DICOM compliance can be modified in steps of 5% starting from 5 to 30%. When
the maximum deviation is not bigger than the selected threshold, the compliance check will be OK.
To set the DICOM error threshold:
1. Bring up the OSD menu.
2. Navigate to the Embedded QA menu.
3. Enter the DICOM Error Threshold submenu.
4. Set DICOM error threshold as desired and confirm.
4.15.5 Reset DICOM calibration
About reset DICOM calibration
It is possible to restore the original (factory default) DICOM curve.
To reset the DICOM calibration:
1. Bring up the OSD main menu.
2. Navigate to the Embedded QA menu.
3. Enter the Reset DICOM Calibration submenu.
4. Select Confirm to restore the original (not corrected) DICOM curve.
4.16 Image source
About the image source
By default, your Nio 2MP / 3MP LED Display automatically detects the connected image sources. You can
also manually select the image sources via the OSD menu.
The Image Source menu is not available when the KVM switch is enabled. (to disable, see “KVM
switch”, page 35 )
To automatically select image sources
1. Bring up the OSD main menu.
2. Navigate to the
Image Settings menu.
3. Enter the Image source submenu
4. Select Auto and confirm.
To manually select image sources
1. Bring up the OSD main menu.
2. Navigate to the
Image Settings menu.
3. Enter the Image source submenu
4. Select DisplayPort 1 or DisplayPort 2 as desired and confirm.
Advanced operation