More details: see NGS-D320 User Guide
1 Connecting your device
NGS-D320
Quick Start Guide
3 Setup wizard
2 Locate your device on the network
Install the NGS-D320 in the network. Connect the display(s), switch, PC, keyboard &
mouse, headphones, microphone, loudspeaker, etc... as applicable.
Detect the IP address of your NGS-D320. You can either detect this via
a. The OSD display output at device start-up
b. Or, the Barco Device Discovery Tool available at
Open your web browser to configure the NGS-D320.
Enter the IP address of your NGS-D320 into the address bar of your web browser
and trust the connection to access the web configuration.
a
b
Select NGS-D320
Click the link to
access the NGS-D320
setup Wizard.
Choose the device
serial number from
the list or enter the
serial number in the
space below to quickly
find the device.
Setup steps:
1. Set the administrator password:
At first usage, the web interface will ask to set
the admin password; this password is needed to change the configuration of the
device later on.
2. Set the logical name for the device:
In Device info change the name of the device,
press Apply.
3. If not using DHCP, set the network settings:
In Network Settings, fill in IP address,
Subnet mask and Gateway IP address. Press Apply.
4. For Encoders:
In Encoder Settings, fill in multicast address and port for each of the
streams in the destination field and press Apply.
5. For Decoders:
In Decoder Settings, click the Content Combo box and choose the
content you want to decode.
6. Discover:
Press discover to show other devices on the network and configure
them.
Encoder installation
Decoder installation
Encoder and decoder installation (NGS-D320 Pro only)
http://www.barco.com/networktools
© 2016 Barco N.V.
| All rights reserved. Subject to change without notice.
K5903139-00
Installation diagram
You may need to press the
identification button you find
next to the network connector.
