Installation
16
Figure 6
2.
Connect the other end of the VGA cable to the analog video output
of the signal source.
Note:
If you connect an analog video signal, you may need to
perform some image adjustments to obtain optimum image
quality. Please refer to chapter “Operation”.
Connecting analog video to the BNC inputs
The video signal must be monochrome. You should use a proper video
cable (e.g., from VGA to BNC). This cable is not delivered with the
system.
Proceed as follows:
1.
Connect one end of the signal cable to the analog video output
(monochrome) of the signal source.
2.
Connect the Video signal to the display’s BNC input labeled
“Video”.
3.
In case of separate video and sync signals, connect the horizontal
or composite sync signal to the display’s BNC input labeled “HS/
CS”.
4.
In case of separate video and sync signals, connect the vertical
sync signal to the display’s BNC input labeled “VS”.
