Barco MES ACURAS HEAD, User And Installation Manual

Page: 42 / 131

7. Installation
D RJ 45 connector lid open
7.2.5 Connection diagram
Diagram
A
C
D
TO
P
TO
P
E
B
F
Image 7-16
Connection diagram
A SFTP Cat 5e cable
B Auto Alignment Head
C LEXUnit
D MCU
E Power to the XDS RACU MCU from the mains power supply (wall outlet)
F Power to the Auto Alignment Head from the mains power supply (wall outlet)
7.3 Uploading the calibration fi les
Overview
• Uploading the spectrometer calibration fi le
• Uploading the camera calibration fi le
7.3.1 Uploading the spectrometer calibration fi le
Overview
A set of calibration data is required to guarantee accurate measurements of the spectrometer. This calibration data is available in
the calibration
fi le ( < fi lename>.cal ) on the CD-ROM which is delivered with the Auto Alignment Head. The calibration fi le must be
uploaded to the MCU, prior to connecting the spectrometer to the MCU.
How to upload the spectrometer calibration fi le?
1. Run the Barco delivered CD on the MCU.
2. Copy the correct spectrometer calibration fi le called < fi lename>.cal .
3. Save the spectrometer calibration fi le to the following location on the MCU, without changing its name
- C:\Program Files\Barco\XDS\Resources\Spectrometer\<serial number> .
7.3.2 Uploading the camera calibration fi le
Overview
By default, the camera is fully calibrated and no further action is required to guarantee correct measurements. For future applications,
it might be required to upload a new calibration
fi le to the MCU. At that time, the calibration fi le will be provided by Barco.
How to upload the camera calibration fi le?
1. Save the camera calibration fi le to the following location on the MCU, without changing its name
34 R59770509 MES ACURAS HEAD - AUTO ALIGNMENT HEAD 24/11/2010