Barco MDSC-2242, User Manual, Page: 28 / 64

K5903030 (451920611336) /05 MDSC-2242
28
4.1 On/Off switching
To switch on/off your display:
1. Power on/off your display using the mains switch located on the back of the display.
While your display is on, press and hold the stand-by key for approximately 2 seconds to put the
display in the stand-by mode.
While your display is in stand-by mode, press and hold the stand-by key for approximately 3
seconds to activate the display.
4.2 Power led status
About the the power led status
The behavior of the power led shows the status of the unit:
• No led visible: the status of the unit is hard OFF (the switch of the power supply is OFF)
• Led is fading between on and off: the status of the unit is soft OFF (when pushing the standby button, the
unit is on or off)
• Led is full orange: the unit is in power save mode (no signal & power save mode enabled)
• Led is blinking green/orange: the unit is in searching mode (looking for a signal)
• Led is full green: the unit has an image on the screen.
4.3 OSD menu activation
To activate the OSD menu
1. If not already done, switch on the display and verify that it is not in stand-by mode (see “ On/Off switching ” ,
page 28.
2. Press the Menu/Enter key .
As a result, the OSD main menu comes up in the bottom right corner of the screen. If no further actions are
taken within the following 30 seconds, the OSD menu will disappear again.
The time-out of the OSD menu automatic close function can be adjusted or disabled in the OSD
menu (
OSD Time-out ).
The OSD menu position can be adjusted in the OSD menu ( OSD Hor. Pos. and OSD Vert. Pos. ).
4.4 OSD menu navigation
OSD menu structure explained
Below is on example of how the OSD menu structure looks like:
Daily operation