Barco Loki, Installation Manual

Page: 46 / 128

601 – 0445 /05 Loki 46
4.4.5 Going from READY to ECO standby
Description
If ECO Standby mode is enabled in the service menu (refer to the section "GUI - system settings/Standby
ECO", in User Guide) the projector will automatically go to
ECO standby mode after a time-out (default 15
minutes). All electronics (including fans, pumps,...) go down except for a very small wake up controller. The
Power on/off button will FLASH WHITE every second.
4.4.6 Going from ECO to ON
Description
Press the Power on/off button on the projector, or the Power On button on the remote control. The projector
goes from ECO directly to ON . The projector will go through the same booting phase as on power plugging,
then do the transition from READY to ON . Of course startup-time will be longer then from READY to ON .
4.4.7 Wake On LAN (WOL)
About
The projector has WOL functionality, that can be used for the projector to go from ECO mode to READY
mode. Use a json command for transition from READY to ON.
The WOL is performed by sending a Magic Packet followed by the projectors MAC address. The MAC
address is found in the menu
Home / System settings / Communication / LAN. The MAC address is similar to
the HW address that is shown in this menu path.
The LAN cable must be connected when the projector enter the ECO mode, in order to obtain the
Wake on LAN function.
4.5 Power modes
General
The table below details the Loki power modes.
Mode
Description
Normal Projector is booted up and the light source is on
Ready Projector is booted up but the light source is off
ECO Standby Light source is switched off and projector electronics
are powered down
4.6 Customize projector settings
About
The projector display, behavior and user interface can be adjusted to meet individual requirements.
Options include: Home/System Settings/Themes
• Adjust the OSD menu color
4.7 User interface
Overview
•
On Screen Display (OSD)
Getting started