2. Unpacking and installation
Barco - LC series - R5976934 - user's manual - Revision 05 - March 2006
_____________________________________________________________________________________
2-7
2.3.3
Rear view
On the rear, all interfaces as well as the power connector and the main power switch are located.
The standardized power socket is conform to IEC-320-13 and allows connecting local power cables. The internal
power supply is auto ranging from 100VAC to 240VAC.
The monitor allows connecting the following sources:
Input
Interface
signals
Video system input
VIDEO IN
RCA
NTSC/PAL
S-VIDEO
S-Video Mini Din 4pin
NTSC/PAL
YUV (Y Pb/Cb Pr/Cr) Component Mini Din 7 pin NTSC/PAL
RGB input
RGB Analog
D-Sub 15 pin
RGB analog
RGB Digital
DVI-D 24 pin
RGB digital
Signal receive&transmit
RS232 IN
D-Sub 9 pin
RS232 OUT
D-Sub 9 pin
Audio
RCA
(red: right (R),
white:left (L))
Audio in (L+R)
Audio out(L+R) (2x) and
Subwoofer
The pin assignments of the interfaces are listed in chapter
7.6 Interfaces
and chapter
8.6 Interfaces,
respectively.
SW
R/IN
R/OUT2
R/OUT1
L/IN
L/OUT2
L/OUT1
RS232/IN
RS232/OUT
RGB IN
DVI
Pr/Cr
Pb/Cb
Y
S-VIDEO
IN
VIDEO
AC IN
OFF
ON
MAIN POWER
Two sources can be viewed simultaneously in either PIP mode (Picture-in-Picture) or PAP mode (Picture-and-
Picture). In case more than one source is connected, the active sources and the display mode (one source or two
sources) are selected via the OSD.