ImagePRO-II • User’s Guide
25
4. Menu Orientation
Quick Setup and Operation
nìáÅâ=pÉíìé=~åÇ=léÉê~íáçå
To quickly set up and begin operating your system, follow the steps in this section. Links
are provided to the appropriate sections in this guide, if you require more information.
1. Connect
power
— Ensure that power is properly connected to the ImagePRO-II.
2. Connect
inputs
— Connect all input sources to the ImagePRO-II. (Chapter 3,
3. Connect
outputs
— Connect the output(s) on the ImagePRO-II to your
projector(s) or other target devices. (Chapter 3,
4. Turn
on
power
— Turn on power to the ImagePRO-II, your projector(s), and to all
peripheral equipment. (This chapter,
5. Factory
reset
— If you are using the ImagePRO-II for the first time, or if you are
using an ImagePRO-II that has just returned from another event, perform a full
factory reset to restore default system configurations. (This chapter,
6. Read the output format
— If the primary output is connected to an HDMI, DVI-D,
HD-15 or DisplayPort connector, obtain the output’s preferred resolution and
frame rate. This is the format the ImagePRO-II uses. (This chapter,
7. Adjust output format
— If the primary output is connected to the composite
video connector or one the SDI connector, you can adjust the output format
manually if necessary. (This chapter,
8. Test
output
— Turn on a test pattern, verify that you have an image, and make
any necessary adjustments. When complete, turn off the test pattern. (This
chapter,
9. Save
output
configuration
— After completing output adjustments, save the
output configuration. (This chapter,
Saving an Output Configuration
10. Position the image
— From a single convenient menu, you can quickly place the
image where you want it on the output display device, then scale it up or down,
and apply masks if necessary. Then you can save your changes and press an
input button to begin your presentation. (This chapter,
11. Set and adjust inputs
— As required, select an input and adjust color balance,
timings, and any other settings necessary.
(This chapter,
,
12. Save input configuration
— After completing all adjustments for an input, save
the input configuration. (This chapter,
13. Repeat for each input
— Repeat the previous two steps for each input
connected to the ImagePRO-II.
14. Adjust system parameters
— As required, adjust system parameters such as
ImagePRO-II display brightness and HDCP settings. (This chapter,
Note
The preceding step provides a reliable shortcut when your
setup does not require complex adjustments. Use this step
instead of or in conjunction with steps 11 through 13.