Barco ImagePRO-II Jr, User Manual Addendum, Page: 50 / 166

ImagePRO-II • User’s Guide 35
4. Menu Orientation
Configuring Inputs
`çåÑáÖìêáåÖ=fåéìíë
The Input Menu is used to adjust all parameters relating to inputs. Using this menu, you
can set all of the configuration options for the selected input.
This section provides detailed information about setting up and using inputs. To quickly
position and size video on an LED wall or monitor, refer to
Setting up an LED Wall on
page 101 of this chapter.
fåéìí=jÉåì=qêÉÉ
The following figure illustrates the Input Menu tree.
Figure 4-2. Input Menu Tree
Edge Timing Adj
Right Edge
Left Edge
Top Edge
Bottom Edge
*When 1:1 Sample is off,
Timing Adjust becomes
Edge Timing Adjust :
Type
Input
Input Format
Colorspace
1:1 Sample
Aspect Ratio
Set Mode
Ratio
Gamma
Processing
3D Mode
DeIntlc
Motion Thresh
Saturation
Contrast
Brightness
Recall Config
Save Config
Reset Config
Delete Config
Red Contrast
Red Bright
Grn Contrast
Grn Bright
Blue Contrast
Blue Bright
Hue
Color Balance
Reset All
Sizing Adjust
Mask Presets
Mask Left
V Size
H Pos
V Pos
Mask Top
Mask Bottom
Mask Right
H Size
Reset Mask
Reset Size
Timing Adjust*
Sample Phase
H Total
H Position
H Active
V Total
V Position
V Active
3D Swap
3D Sample
3D MiniDin
Swap
3D L/R Status