Barco ICP-D, Installation Manual

Page: 11 / 54

11 R5912083 /01 ICP-D
1.3 Initial inspection
General
Before shipment, the ICP-D was inspected and found to be free of mechanical and electrical defects. As soon
as the ICP-D is unpacked, inspect for any damage that may have occurred in transit. Save all packing material
until the inspection is completed. If damage is found, file claim with carrier immediately. The Barco Sales and
the Service office should be notified as soon as possible.
Unpacking
At delivery the ICP-D is packed in a cardboard box. Place the cardboard box on a stable (solid), flat and
insulated support during all the unpacking. Open the box from the top. Remove the ICP-D that is packaged in
an antistatic bag. Check the box content after unpacking.
After unpacking let the ICP-D acclimate to the room temperature which must be higher then 10°C
(50°F) and lower then 35°C (95°F). Neglecting this may result in startup failure of the device.
Save the original shipping cardboard box and packing material, these will be necessary if you ever
have to ship your ICP-D. For maximum protection, repack your ICP-D as it was originally packed at
the factory.
Box content
After unpacking the ICP-D it is recommended to check if all following items where included:
• ICP-D assembly
Mechanical check
This check should confirm that there are no broken knobs or connectors, that the front face is free of dents and
scratches, and that the different elements (main board and front face) forms a unified and coherent assembly.
The Barco Sales and the Service office should be notified as soon as possible if this is not the case.
Tamper labels
Prior to installation inspect the tamper labels of the ICP-D assembly. If the tamper labels are damaged please
contact Barco technical support.
The tamper labels are required to provide easy visual indication if the equipment was tampered with. The ICP-
D is tested and labeled for shipping to ensure that the system was not compromised before reaching the
customers final destination.
These tamper labels can be found on top of the ICP-D assembly (reference 1 Image 1 – 1). Damaged tamper
labels may indicate an intrusion attempt into the security module of the ICP-D. This should be reported
immediately to the Barco Sales and the Service office.
1
Image 1 – 1
General