Barco HDX series, User And Installation Manual, Page: 184 / 340

12. Alignment
Or,
press
ENTER when an item is selected and use the 4 arrow keys to adjust.
Image 12-43
Warping, keystone
5. Move the corner points to the desired position.
Image 12-44
Keystone adjustment
12.8.9 Linearity adjustment, work fl ow
Adjusting vertical and horizontal linearity
1. Select the 2 x 2 adjustment level. See "Setting the warping level", page 177.
The default selected anchor point is the left top corner of the image.
2. Select the desired warp area.
Depending on the selected area only the points in that area will be adjusted.
3. Select Linearity.
4. Select within Warp Adaptations , Horizontal or Vertical to adjust the corresponding keystone.
Or,
press
ENTER when an item is selected and use the 4 arrow keys to adjust.
Image 12-45
Warping, Linearity
5. Adjust the horizontal and vertical linearity.
To fi ne tune this adjustment, select a speci fi c area and add extra anchor points by changing the warp level.
180 R5905032 HDX SERIES 20/11/2014