Barco HDX 4K, User Manual

Page: 17 / 107

2. Installation preparations
Image 2-2
Remove carton and foam rubber
3. Take out the foam rubber.
4. Take out the projector.
Save the original shipping carton and packing material, they will be necessary if you ever have to ship your
projector. For maximum protection, repack your projector as it was originally packed at the factory.
A rubber foam inside a plastic bag is placed into the lens opening of the projector. It’s recommended to reuse
this foam and plastic back each time you transport the projector. This to prevent intrusion of dust and foreign
particles.
The lens is delivered in a separate box.
2.3 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As soon as the projector is
unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If
damage is found,
fi le claim with carrier immediately. The Barco Sales and Service of fi ce should be noti fi ed as soon as possible.
The packaging of the HDX is provided with a shock-watch label. If this shock-watch label was triggered (red
colored at arrival) during transport, that indicates that the package was possibly roughly handled by the trans-
port company. In this case, the instructions mentioned on the label, should be followed, which are: adding
a note on the “bill of lading” and informing the transport company and the Barco sales and service of
fi ce as
soon as possible.
Box content
After unpacking the projector it is recommended to check if all following items where included:
R5906070 HDX 4K 23/09/2016 13