3. Physical installation
3.8
Adjusting the multifunctional frame
Introduction
The Barco HDQ 4K35 is mounted by default in a multifunctional frame. This frame can be used to adjust the projector position. The
frame can be adjusted in 3 different ways:
•
inclinating
•
rotating
•
skewing
The image below explains these 3 terms.
A
C
B
Image 3-16
A
Inclinating
B
Rotating
C
Skewing
Necessary tools
•
2.5 mm Allen wrench
•
17 mm wrench
How to inclinate and rotate the projector in the frame?
1. Release the locking screw(s) (1) on the adjustment mechanism(s) on the back of the frame. Use a 2.5 mm Allen wrench.
2. Turn the left and right adjustment screw (2) anti clockwise to lower the back of the projector
Or,
clockwise to rise the back of the projector.
Note:
A 17 mm wrench can be used to turn the adjustment screws.
3. Turn the left and right adjustment screw (2) in the opposite direction to rotate the projector.
4. Tighten the locking screw(s) (1). Use a 2.5 mm Allen wrench.
30
R5905823 HDQ 4K35 30/11/2015
Summary of Contents for HDQ 4K35
