3. Physical installation
3.5
Connecting a UPS to the projector electronics
UPS
Uninterruptible Power Supply
Introduction
This procedure explains how the projector electronics can be connected with a UPS. By default, the projector is con
fi
gured for use
without a UPS. A short power link cable (with plug type C13/C14) loops the power through to the projector electronics.
W
ARNING
:
Only use UPS units which are suitable for the HDQ 4K35.
How to connect a UPS to the projector electronics?
1. Install the UPS according to the instructions of the manufacturer and the local regulations.
2. Remove the short power link cable if present:
a) Remove both
fi
xation springs (1) by squeezing them together and pulling them away from the power plugs.
b) Unplug both power plugs from the short power link cable (2).
1
1
2
Image 3-8
3. Connect the power output cord from the UPS unit (1) to the UPS inlet socket of the projector (right socket) (2).
Tip:
Position the cable behind the back cover instead of directly connecting the power plug. This will make it possible to
remove the back cover without unplugging the UPS inlet cable.
1
2
1
Image 3-9
4. Secure the UPS inlet socket with a
fi
xation spring:
R5905823 HDQ 4K35 30/11/2015
23
Summary of Contents for HDQ 4K35
